top of page

40MM Cooling Fan Kit 

 

This 40mm Cooling Fan Kit includes all the electronic components needed to connect a fan to your extruder assembly for cooling prints. The use of a cooling fan will drastically improve your models and allow you to print at a faster speed.

 

Compatible with all Duplicator 4 series printers.

 

Included are: (x1) 40mm Fan with male 2-Pin connector, (x1) Mosfet Chip, (x1) MightyBoard female 2-Pin Connector, (x2) 1.5 meter 22AWG Hookup Cables, (x2) Heat Shrink Tubes.

 

*Please Note:This kit does not include a fan bracket. We have a link to a printable fan bracket on our printable parts page HERE

 

 

*Please Note: In order to connect this kit you must have a soldering iron. In addition, you risk destroying your Mightyboard (Micro-controller) by connecting this kit incorrectly. This should only be attempted by persons with advanced electronics skill. Incorrect installation of this kit and the resulting damage may void your limited warranty with Ultimate 3D Printing Store. 

Disclaimer - Price is for one part only. Image above may show multiple parts.

WANHAO PARTS DEPARTMENT  

 

WANHAO DUPLICATOR 4 SERIES GENUINE REPLACEMENT PARTS 

USA WANHAO

© Copyright 2022 | Powered By Unlimited Media Marketing™ | All Rights Reserved

bottom of page